Motion and Position Sensors
-
Motion and Position Sensors
ADXL335 3-axis Analog Output Accelerometer Module
₹575.00 Read moreOperating Voltage: 3V – 5V DC
Sensing Range: ±3g (X, Y, Z axes)
Output Type: Analog (X, Y, Z axis)
Sensitivity: 330mV/g at 3.3V supply
Bandwidth: Selectable via external capacitors
Current Consumption: ~350 µA
Dimensions: Compact size for embedded applications
Applications: Tilt sensing, vibration monitoring, motion tracking, gaming controllers -
Motion and Position Sensors
ADXL345 Triple Axis Accelerometer Board
₹180.00 Add to cartSupply Voltage: 3.3 V or 5V.
Sensitivity: X: 28.6 LSB/g, Y: 31.2 LSB/g, Z: 34.5 LSB/g.
Output data rate (ODR) : 800 Hz
Sensing Range: ±2g, ±4g, ±8g, ±16g. -
Motion and Position Sensors
Float Sensor Switch For Water Level Controller
₹112.00 Add to cartSpecifications and Features:
Length of the contact cable: 30.5(cm)
Type of Sensor : Magnetic reed based Float Sensor
Maximum Load : 50 W
Max Switching Voltage : 100V DC
Maximum Switching Current : 0.5 A
Max Contact Resistance : 0.4 Ω
Temp Rating: -20~ 80 degree
Material: High Quality Plastic Based -
Motion and Position Sensors
HMC5883L 3-axis Electronic Compass Module Magnetic Field Sensor
₹160.00 Read moreDriver IC:HMC5883L
Type:GY-271
Operating Voltage (VDC):3 ~ 5
Communication:I2C Protocol
Measuring Range:± 1.3-8 Gauss
Length (mm):14.8
Width (mm):13.5
Height (mm):3.5
Weight (gm):2 -
Motion and Position Sensors
MPU6050 Module – Triple Axis Accelerometer And Gyro Module
₹169.00 Add to cartChip: MPU-6050
Operating Voltage(VDC): 3 to 5
Communication mode: I2C
Chip built-in: 16bit AD converter
Gyroscopes Range: +/- 250 500 1000 2000 degree/sec
Acceleration Range: +/- 2g, 4g, 8g, 16g
Sensitivity: up to 131 LSBs/dps
Pin pitch: 2.54 mm
PCB Size (mm): 20 × 16
Weight: 4 gram -
Motion and Position Sensors
MPU6050 Module – Triple Axis Accelerometer And Gyro Module – Original Chip
₹450.00 Add to cartChip: MPU-6050
Operating Voltage(VDC): 3 to 5
Communication mode: I2C
Chip built-in: 16bit AD converter
Gyroscopes Range: +/- 250 500 1000 2000 degree/sec
Acceleration Range: +/- 2g, 4g, 8g, 16g
Sensitivity: up to 131 LSBs/dps
Pin pitch: 2.54 mm
PCB Size (mm): 20 × 16
Weight: 4 gram -
Motion and Position Sensors
MPU9250 9-Axis Attitude Gyro Accelerator Sensor Module
₹380.00 Add to cart9-axis sensing: Gyroscope + Accelerometer
High-resolution motion tracking with low noise
Supports I²C and SPI communication
Built-in magnetometer for accurate heading/compass data
Wide selectable gyroscope & accelerometer ranges
Compact, lightweight module for wearable and embedded systems
Compatible with Arduino, ESP8266/ESP32, STM32, Raspberry Pi, etc.
Ideal for drones, robotics, gesture control, VR/AR devices, IMUs, and navigation projects -
Motion and Position Sensors
TCRT 5000 Module Line Sensor
₹45.00 Add to cartSpecifications:
TCRT5000 reflective optical sensor
Line follower robots, sumo/mini sumo robots
Digital output
Operating Voltage: 5V
Operating Current: <10mA Size: 30 mm x 16 mm -
Motion and Position Sensors
Tilt Sensor Vibration Alarm Vibration Switch Module for Arduino
₹46.00 Add to cartOperating voltage of this module is 3.3 to 5 VDC.
High sensitivity angle switch SW-520D as sensor
Comparator output, clean signal
Good waveform, strong drive ability, more than 15mA
With a fixed bolt hole, easy to install
Using wide voltage LM393 comparator -
Motion and Position Sensors
Vibration Sensor Module (SW-420)
₹50.00 Add to cartOperating Voltage: 3.3V to 5V DC
Operating Current: 15mA
Using SW-420 normally closed type vibration sensor
LEDs indicating output and power
It uses wide voltage LM393 comparator
Output format: digital switching output (0 and 1) -
Motion and Position Sensors
Water Flow Sensor YF-S201
₹250.00 Add to cartSpecifications:
Model: YF-S201
Sensor Type: Hall effect
Working Voltage: 5 to 18V DC (min tested working voltage 4.5V)
Max current draw: 15mA @ 5V
Output valve Size: 20mm
Output Type: 5V TTL
Working Flow Rate: 1 to 30 Liters/Minute
Working Temperature range: -25 to +80℃
Working Humidity Range: 35%-80% RH
Accuracy: ±10%
Maximum water pressure: 1.75 MPa
Output duty cycle: 50% +-10%
Output rise time: 0.04us
Output fall time: 0.18us
Flow rate pulse characteristics: Frequency (Hz) = 7.5 * Flow rate (L/min)
Pulses per Liter: 450
Durability: minimum 300,000 cycles
