Shop
-
Environmental Sensors
MQ-5 Methane LPG Liquid Propane Gas Sensor Module
₹110.00 Add to cartDetecting Concentration: 300 to 10000 ppm
Input Voltage: 5 VDC
Power: 150 mA
Digital Output Voltage: TTL digital 0 and 1 (0.1 V and 5 V)
Analog Output Voltage (relatively clean): 0.1 V to 0.3 V
Analog Output Voltage (highest concentration): 4 V -
Environmental Sensors
MQ-6 Gas Sensor For Propane, Butane, And LPG Detector Module
₹120.00 Add to cartThis is MQ-6 Gas Sensor Module
Simple and easy-to-use device to detect LPG, propane, butane, and natural gas concentrations in the air.
Sensitivity range from 200 to 10,000ppm.
High sensitivity and fast response times.
Output is an analog resistance, which can be easily connected to an ADC.
Low-cost device suitable for a range of applications.
Can be used as a digital or analog sensor and the sensitivity of the digital pin can be varied using the potentiometer. -
Environmental Sensors
MQ-7 Module (Carbon Monoxide Gas Sensor)
₹120.00 Add to cartOperating voltage: DC 5 V.
The analog output voltage, the higher the concentration the higher the voltage.
The carbon monoxide detection with better sensitivity.
With a long service life and reliable stability.
Rapid response and recovery characteristics.
Range: 10 to 1000 ppm.
-
Environmental Sensors
MQ2 Smoke and Gas Detector Sensor module
₹110.00 Add to cartOperating Voltage is +5V
Analog output voltage: 0V to 5V
Digital Output Voltage: 0V or 5V (TTL Logic)
Preheat duration 20 seconds
Can be used as a Digital or analog sensor
The Sensitivity of Digital pin can be varied using the potentiometer -
Boost Converter (Step up)
MT3608 DC Step Up Boost Voltage Regulator Module with USB
₹45.00 Add to cartMT3608 5A Module Specifications:
Input voltage range: 2V-24V DC
Output voltage range: 5V-28V DC adjustable.
Output current: 0-2A.
High efficiency 93%
The built-in thermal shutdown function
Built-in 4A current limit function
In-Built output short protection function -
DC Motors
N20 12V 100RPM Micro-Geared DC Motor
₹250.00 Add to cartVoltage: 9-12 V DC
Torque: 10.7oz (0.4 kg).in (0.77 kg-cm)
Current: 48mA
Stall Current: 390mA
Reduction: 100:1 -
Arduino Compatible Boards
Nano CH340 Chip Board without USB cable compatible with Arduino (Soldered)
₹220.00 Add to cartSpecifications:
Operating Voltage (logic level): 5V
With Soldered Connector
8 analog inputs ports: A0 ~ A7
14 Digital input / output ports: TX, RX, D2 ~ D13
1 pair of TTL level serial transceiver ports RX / TX
Using Atmel Atmega328P-AU MCU
There is a bootloader installed in it
Standard 0.1” spacing DIP (breadboard friendly).
Manual reset switch. -
ESP8266
NodeMCU ESP8266 CP2102
₹250.00 Add to cartLowest cost WI-FI
Integrated low power 32-bit CPU
Arduino-like hardware IO
Upload codes from the Arduino IDE
Wi-Fi Module – ESP-12E module similar to ESP-12 module but with 6 extra GPIOs.
USB – micro USB port for power, programming and debugging
Headers – 2x 2.54mm 15-pin header with access to GPIOs, SPI, UART, ADC, and power pins
Flash Memory(Mb):4
Support:SDIO 1.1/2.0, SPI, UART
Length (mm):49
Width (mm):24
Height (mm):13
Weight (gm):8
Misc – Reset and Flash buttons
Power – 5V via micro USB port
Dimensions – 49 x 24.5 x 13mm -
Environmental Sensors
NTC Thermistor Temperature Module
₹45.00 Add to cartNTC thermistor sensor, good sensitivity
The comparator output signal is more than 15mA.
Possible to adjust the temperature distribution position detection threshold
Working voltage: 3.3V-5V
Output form: DO digital switching outputs (0 and 1) and AO analog voltage output
Fixed bolt hole for easy installation
Small PCB board size: 3.2cm x 1.4cm
uses a wide voltage comparator LM393
Compatible with arduino . -
Electrical Sensors
Peacefair PZEM-004T AC Multi-function Electric Energy Metering Power Monitor
₹750.00 Add to cartSpecifications:
Product Type: AC Energy Meter / Power Monitor
Model: PZEM-004T
Operating Voltage: 80–260 VAC
Test Voltage: 80–260 VAC
Rated Current: 100 A
Rated Power: 22,000 W (100A @ 220V)
Operating Frequency: 45–65 Hz
Measurement Accuracy: Class 1.0
Phase Type: Single Phase AC
Current Measurement: External Current Transformer (CT)
Applications: Energy monitoring, smart meters, industrial panels, home automation, DIY electronics -
Distance and Proximity Sensors
PIR Sensor Module HC-SR501
₹75.00 Add to cartWide Working Voltage Range: DC 4.5V- 20V
Current Drain: <60uA Detection Angle: <140° Detection Distance: 3 to 7m (can be adjusted) Blockade time: 2.5s (Default) Work temperature: -20-+80°C
-
Environmental Sensors
PM2.5 GP2Y1010AU0F Dust Smoke Particle Sensor
₹580.00 Add to cartPower supply voltage: DC5 ± 2V
Sensitivity: 0.5V / (0.1mg / m3)
The minimum detection level of particles: 0.8 m
Clean air voltage: 0.9V typ.
Low consumption current (Icc: MAX. 20 mA)
The presence of dust can be detected by the photometry of only one pulse
Enable to distinguish smoke from house dust
